Identificador: 2059
Abierta
Descripción
PARTE: 12433 - MOLDURADORA - 6 CABEZALES - LEADERMAC COMPACT 623
USADA - BUENAS CONDICIONES
Voltage: 550/3/60
CSA Hydro approved
Head Sequence: Bottom, Right Side, Near Side, 1st Top, 2nd Top, 2nd Bottom
9 1/16” x 6” Capacity
Infeed Straightening Table -Sound Enclosure
Total H.P. 95.75 - Largest H.P. 20
Total Amperage 107.2
40 mm Dia Spindles
Pago y Devoluciones
- Forma de pago
- Visa/Mastercard/American Express, Transferencia/Deposito Bancario
Publicar mensaje
Ingresar to ask the seller a question.
AMXmachinery
TOLVA - PARA EXTRACTORES DE POLVOS Y ASERRIN
PARTE: AMX-10136 - TOLVA - PARA EXTRACTORES DE POLVOS Y ASERRIN
USADO - BUENAS CONDICIONES
MEDIDAS TOTALES: ANCHO 28” X 23”
FONDO X 35” ALTO
DIAMETRO ABAJO INTERIOR 9”
DIAMETRO ABAJO EXTERIOR 12”
DIAMETRO SUPERIOR 23”
DIAMETRO SALIDA SUPERIOR LATERIAL
6”
4,500.00 MXN
AMXmachinery
ESPIGADORA DOBLE DE CADENA - SCMI
PARTE: 12413 – ESPIGADORA DOBLE DE CADENA - SCMI
USADA - BUENAS CONDICIONESSCMI Concept 2000 •
Opening Capacity: ~4'•
Two-Post Machine• First
Station: Left & Right Trim Saws• Trim
Saw Motors: 8 HP Each• Second
Station: Left & Right Jump-CopeUnits,
7000 RPM• Jump
Cope Motors: 11.5 HP Each• Third
Station: Left & Right Cope Units, 7000RPM• Cope
Motors: 11.5 HP Each• Load
Space: 32"• Rubber
Padded Feed Chains 2.75" Wide• Pop-Up
Dogs on 14-3/4" Centers•
Push-...
AMXmachinery
RESACADORA SENCILLA – 60” CAPACIDAD LARGO
PARTE: 2FA-NXL-48 – RESACADORA SENCILLA
– 60” CAPACIDAD LARGO
NUEVA CON GARANTIA
HASTA 800 RESAQUES/HRStandard FeaturesCutter Head is Never ExposedTable Moves w/Dual Air Rams Á Linear BearingsDouble Clamp System Machine SpecsDimensionsLength: 60"Width: 90"Height: 50"Table Height: 37" Power20 HP Electric Motor: 208/230/480/3/60 TEFCCompletely pre-wired motor starter with start/stop
buttons and circuit overload protection SpecificationsArbor & Bearing Size: 2"Approx. 2000 lbsTabl...
AMXmachinery
PRENSA DE TABLEROS – 20 SECCIONES – TAYLOR
PARTE # 11913 - PRENSA DE TABLEROS – 20 SECCIONES – TAYLOR8.5 ft. wide with approximately 6 clamps per sectionClamps are standard 2-1/2” high jaws by 32” openingIncludes air tightener and panel flattenerMachine was new in 1983Good conditions